Wattio SIREN Manual página 17

The adaptor must be always
connected.
If an intruders disconnects
the SIREN from the power
supply source,
continue working
ringing thanks
batteries. However, it is very
important to understand
that the batteries as just a
backup for
situations and the SIREN
cannot be used just with
batteries by default, but
with the power adaptor.
Chose a discrete zone without interfering with the speaker.
3º Close to the place chosen to install the SIREN, press B
button to switch it on. The indicator will flash green and
red once, green five times and green six more times in
case it connects correctly.

Otherwise, verify that the GATE is switched on
and the signal requirements have been respected

Otherwise, reset the sensor keeping pressed the B
button (see RESET section) and then switch it on.
4º Place the base on the wall, either with screws or with the supplied adhesive.
It is highly recommended to screw the base to the wall.
It can also be placed with double sided tape, but the fastening power will be lower according
to the Surface. Make sure to place it over a clean and smooth Surface.
it will
and
to the
emergency