Components; Setup / Usage - WAGNER 715 El Manual Del Propietario

CompoNeNts

# part No. DesCrIptIoN
1
------- Water tank
2
2372750 Fill cap
3 2352913 Steam hose
4 2353928 Large steam plate
5 2354013 Small steam plate
6
0283135 Power cord (not shown)
7
0283577 Instruction manual

setUp / UsaGe

Prior to filling, the water tank must rest on a
sturdy, level surface and in an upright position.
1.
Remove fill cap and fill the water tank with clean water to
the MAX level line indicator. Replace the fill cap.
2.
Thread the hose ends to the threaded outlets of the water
tank and the steamplate.
3.
connect the power cord to the water tank. It will take
approximately 15 minutes for the water tank to produce
steam.
A full container will operate for about 70 minutes. To
refill, unplug the power cord and let the steamer cool for a
minimum of 2 minutes.
4.
For best results, use a scoring tool or a putty knife and gently
score the wallpaper in a crisscross pattern. The perforations
will allow the steam to penetrate the wallpaper.
5.
Once steam is flowing out of the steam plate, hold the
steam plate flat against the scored wallpaper for about
10 seconds. Move the steam plate to a new section and
remove the steamed section with the scraper blade.
DO NOT OPERATE ThE STEAMER ONcE ThE
WATER TANK IS EMPTY.
4
4
3
2
1
eN
5
7
1
2
3
4 5
POWER STEAMER 715
OWNER'S MANUAL
EN F ES
READ THIS MANUAL FOR COMPLETE INSTRUCTIONS
FRANÇAIS P. 7
ESPAÑOL P. 13
wagner-group.com 1116 • Form No. 0283577A