Procom Heating NVDWA2 Instrucciones De Instalación página 5

6. Install valve cover to burner pan using self
tapping screws as shown in Figure 4A.
FOR GLASS BURNER MODELS ONLY
Install baffle panel and valve cover to
burner pan using self tapping screws as
shown in Figure 4B.
7. Install safety pilot and piezo ignitor onto
baffle panel using self tapping screws as
shown in Figure 4A and 4B.
Figure 4A
Glass Burner
Models Only
Baffle Panel
Figure 4B
200279-01A
NATURAL GAS INSTALLATION
Safety Pilot
and Ignitor
Assembly
Valve Cover
Safety Pilot and
Ignitor Assembly
Valve Cover
www.usaprocom.com
8. Install the control knob to the control rod
extension. Push the control rod extension
onto the "D" shaped control rod through
the center hole in the cover as shown in
Figure 5.
9. Install the piezo ignitor through hole in the
valve cover. Attach ignitor cable to ignitor.
Control Rod
Control
Extension
Knob
Figure 5
Place the burner pan assem-
bly in the center of the fireplace
floor. Make sure the front of pan
faces forward.
Ignitor
Cable
Control Rod
Ignitor
5