KENMORE ELITE 405.54571 Manual De Uso Y Cuidado página 12

2. Continuous draining
* Water can be continuously drained into a floor drain
by attaching a length of garden hose (ID > 5/16", with
a female threaded end ID 1", not included, ) onto the unit.
* Affach the drain tube to the adaptor A securely.
(See Fig.9, placed in the bucket).
* Remove the rubber plug from the back
drain outlet of the unit and set aside and
remove bucket, then insert the drain tube
through the drain outlet of the unit and
securely press it into the connector on the
front of the unit (See Fig.]0 and Fig.]1).
* Use the two supplied screws to screw adaptor
A to the back of the unit.
*Screw the female threaded end of the garden
hose into the adaptor A (See Fig.]2). Lead the
hose to a floor drain.
Figure 9
Rubber plug
Figure 10
* Make sure the hose is secure so there are no
leaks.
* Direct the hose toward the drain, making sure
that there are no kinks that will stop the
water flowing.
* Place the end of the hose into the drain and
make sure the end of the hose is level or below
the drain outlet on the unit. Never let the hose
run upwards.
* Place the bucket back in the unit and make
sure that it is correctly in place.
* Continuous draining will begin once the unit
begins operation.
3. Pump draining
Water can be automatically emptied into a floor
drain or a suitable drainage facility by attaching
the pump drain out with a pump drain hose
(OD :1/4", supplied ).
* Remove the continuous drain hose and the drain hose
subassembly from the unit. Install the plastic cover to
the continuous drain hose outlet of the unit by using two
screws.(See Fig.13)
Infernal Connector
Drain hose
Figure 11
Garden__
Female /
threaded end
Figure 12
Garden hose
Female
threaded end
Figure 13
12