Operating Instructions; Before Use; Control Panel - Magic Chef MCSRC03ST Manual De Usuario

OPERATING INSTRUCTIONS

BEFORE USE

Before using your rice cooker, be sure to clean the inner pot and accessories with warm soapy water and rinse
thoroughly. Wipe the rice cooker with a soft cloth, and make sure to read all instructions. A burning smell is
normal the first time the cooker is used due to particles on the heater.

CONTROL PANEL

• Rice: Press to cook rice. Indicator will light and the rice cooker
will begin cooking after 5 seconds.
• Time Cook: Press to cook other foods. Indicator will light and
unit will begin cooking after 5 seconds. Time can be adjusted
from 12 ~ 30 minutes in 0.1 hr (6 minute) increments and display
will show remaining cook time in minutes.
• Delay Time: Press to set delay cook time. Indicator will light
when delay is set. Delay can be set between 12 minutes (0.2) ~
12 hours. Each push of the delay button increases the time 0.2
hours (12 minutes) from 0.2 ~ 1.0 hours, and 1 hour between 1
~ 12 hours. While counting down, the display will count hours
from 12 ~ 10, then in 0.2 hour increments.
• Warm/Cancel: When Rice or Cook function is set, press
to Cancel. When no cooking function is set, press to keep
contents of rice cooker warm for a maximum of 12 hours. Indicator will light.
• Display: On Rice cooking function – outer edges flash while cooking. On Cook function, counts down the
cooking time in 0.1 hour (6 minute) increments. On Warming – Displays the amount of time the rice cooker
has been warming in 0.1 (6 minute) increments.
RICE FUNCTION
Measure out the amount of rice to be cooked using the included measuring cup. One scoop is 80g, about ½ a
cup, of uncooked rice, which will yield 1 cup of cooked rice. It is recommended to wash the rice to be cooked
first, which can reduce the amount of water splatter while cooking. Put uncooked rice in the inner pot of the rice
cooker, and add water. For each scoop of rice used, fill the inner pot to the bottom of the corresponding mark
on the side of the pot. For 1 scoop of rice, fill to the bottom of the 1 mark, for 2 scoops, fill to the bottom of the
2 mark, etc. Depending on the type of rice being cooked and personal preference you can adjust the amount of
water added as desired.
Once the rice and water are added, place the lid on the rice cooker and push the rice button. The indicated
light will come on, and the unit will start to cook in 5 seconds. The cook time for the rice will vary based on
the amount and type of rice used, and how much water is added, but will generally go for about 35-45 minutes.
During the rice cooking cycle, the display will flash lines around the outside of the numbers. When the rice is
cooked, the Warming function will begin, and the display will show the amount of time it has been warming in 6
minute (0.1 hour) increments.
8
Figure 3