Razarsharp Minimower Manual De Instrucciones página 4

Fixing the Handle to the Base
11
10
13
8
1
3
4
ASSEMBLY INSTRUCTIONS
6
12
9
7
1
2
3
4
5
2
To fix the handle to the base:
Step 1. Place the lower left handle (1) into the base
housing fitting (3). Make sure the hole (2) of the lower
handle coincides with the hole (4) of the base and attach
the two using screw (5).
Step 2. Carry out the same procedure for the lower right
handle.
Step 3. Get the upper handle (6), place the screw (7) and
tighten it with the butterfly nut (8 and 9).
Step 4. After handles (1 and 6) are assembled, attach the
extension cord mounts (10) using the screw (11) and the
nut (12).
Step 5. Attach the extension cord
support (1) to the upper handle (13).
5
Assembly of Grass Catcher
For proper operation of the
the grass catcher.
Step 1. Start by attaching the 3 rear clamps (Fig 1) then
the clamps on both sides of the cath (Fig 2) each will snap.
Note: The catcher is flexable and may require
alignment.
Step 2. Ensure that all the clamps are secure.
Step 3. Open the deflector cover and attach the catcher
to the mower (Fig 3).
Note: Bring the catcher straight into the back of the
mower. Do not Angle.
Step 4. Release the deflector cover and ensure that the
catcher is secure (Fig 4).
Minimower lawn mower, use
3