Cup Holders - Britax Child Safety SKYLINE Guia Del Usuario

Britax Child Safety, Inc�
Adjusting Head Restraint Height
The head restraint can be adjusted and locked into different
positions� Check the fit with a child seated in the booster seat�
Ensure that the shoulder belt guides are at or just above the child's
shoulder as shown on page 8�
1� Squeeze and hold the head restraint height adjuster to raise or
lower the head restraint�
2� Slide the head restraint up or down to the desired level�
3� Release the adjustment handle, then pull up to ensure the head
restraint has locked into place�
NOTE: Repeat this process until the shoulder belt lies across the
center of the child's chest and is positioned at or just above the
child's shoulder when positioned through the shoulder belt guide.
10

Cup Holders

Installing the Cup Holders
IMPORTANT: DO NOT use cup holders with hot liquids�
1� Slide the cup holder into the booster base and press down until
a click is heard�
NOTE: The cup holders are labeled inside "L" and "R", from the
position of the child occupant, and can only be installed one
way.
Removing the Cup Holders
1� From under the booster base, locate the tab on the bottom of
the cup holder�
2� Pull forward on the tab to disengage the cup holder, then
remove it from the booster base�
NOTE: Cup holders are dishwasher safe.
SKYLINE User Guide
11