SW-Stahl S3250 Manual De Instrucciones página 6

S3250
A portion of the water content, however, is condensed in the piping, and can enter the tool
mechanism, and may cause trouble. So, install an Air Filter, Regulator & Lubrication and on
oilier between the compressor and the tool. Use a 3 HP or larger compressor for enough power.
1.3 Air hose
Clean the hose with a blast of compressed air before connecting the hose to air tool. This will
prevent both moisture and dust within the hose from entering the tool and causing possible rust
or malfunction. To compensate for unusually long hose (over 25 ft), the line pressure should be
increased accordingly.
If the length of air hose over 25ft, it has been suggested to add an Air tank (Capacity 200L) to
prevent tools from too low power to run due to air pressure is not enough.
1.4 Inserted tools
Make sure to use impact-quality socket only, don't use hand-tool sockets. The crack of sockets
will reduce the torque of air tool and may cause serious injury.
1.5
The approved eye protector, ear-muff, mouth-muffle and gloves should be worn when operate
this tool.
1.6
The working place shall be ventilated.
1.7
Release the on-off device in the case of energy supply failure.
2. Operation Method
2.1 On-off device
The on-off device is on the outer contour of the grip. It is a "hold-to-run" type. This tool stops
rotation within few second after releasing the lever. For the sake of safety, place it on a level
plate or on hanger after it completely stops.
2.3 Rotating Direction
One shall make sure the direction of rotation before actuate this tool. The "F" indicates forward
and the "R" indicates reverse. Forward is defined as clockwise direction seen from the operator's
position.
3. Maintenance
3.1 Lubrication
It is the owner's responsibility to lubricate the air tool properly, but don't use any inflammable or
volatile oils for lubricating, i.e. Diesel oil, gasoline or kerosene.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
www.swstahl.de