Things To Remember; Battery Replacement - LiftMaster 815LM Manual Del Usuario

THINGS TO REMEMBER

• Periodically clean the solar panel with a soft cloth and warm
water. Do not hose spray. Keep the collector clear of snow and
leaves. Make sure trees and other objects do not block sunlight
from the panel.
• If not to be used for several weeks, turn the unit OFF. Store it
with the panel connected and where the panel can gather
sunlight.
• Solar collection is only effective in direct sunlight. Every hour
the light is on requires a minimum of 16 hours of sunlight
charging. Solar panels collect less than 10% of the sun's
energy.
• Several days of use with overcast skies may discharge the
battery. Because of the battery protection circuit, the light will
not work until the battery is sufficiently recharged. Note: To
determine if the battery is charged after the initial setup, watch
the red LED on the front of the sensor. If it blinks when motion
is sensed, then the battery is charged. If not, then turn the
ON-TIME switch to off and allow the sun to charge the battery
for 3 to 7 days. Test the battery as described under Initial
Battery Charge, page 1.
• This light is supplied with two permanent LED lamps. The
LED's are rated to provide a minimum of 40,000 hours of light
output and do not need to be replaced.

BATTERY REPLACEMENT

This solar light contains a rechargeable battery that can be
replaced if needed. Rechargeable batteries will eventually lose
their ability to hold a charge. To replace the battery follow the
steps below.
IMPORTANT: The sealed lead-acid battery must be recycled
or disposed of properly
1. Remove rear battery cover. Press in the two catch releases on
the cover and remove the cover.
2. Remove rechargeable battery. Slide battery out of case and
remove the wire connectors from the battery.
3. Replace battery. Connect the RED wire connector to the positive
(+) terminal and the BLACK wire connector to the negative (-)
terminal. Wire connectors should fit tightly. If not, remove the
wire connector from the terminal. Use a pair of pliers to gently
squeeze the connector to ensure a tight fit. Reconnect wire
connector to the terminal.
4. Replace battery cover. Insert the two tabs on the cover into the
slots on the back of the case. Press the cover against the case
until the two catch releases snap into place.
IMPORTANT: Keep sensor switch in the "OFF" position for 3
to 7 days to allow the battery to fully charge before testing.
Tab Slots
Rechargeable
Battery
Battery
Cover
SPECIFICATIONS
Range . . . . . . . . . . . . . . . . . . . . . Up to 70 ft. (21 m); [varies with
Sensing Angle . . . . . . . . . . . . . . . Up to 180°
LED (x2) . . . . . . . . . . . . . . . . . . . 6 watts
Battery Type . . . . . . . . . . . . . . . . Sealed lead acid, 6 V 5.5 A-Hr.
On Time . . . . . . . . . . . . . . . . . . . TEST (5 seconds), 1 or 5
Full Charge on Time . . . . . . . . . . Up to 2 hours
IMPORTANT: DO NOT reverse the battery wires. Damage to
the unit will result. Like any lead-acid battery, this battery
must be disposed of properly.
LiftMaster reserves the right to discontinue products and to
change specifications at any time without incurring any obligation
to incorporate new features in products previously sold.
4
Positive Wire
Negative Wire
Battery Cover Catch Release
surrounding temperature]
minutes, OFF, selectable