Light-N-Carry LNC1841 Manual Del Operador página 5

FEATURES
- ON/OFF Power Button
- COB LED Work Light with 2 Settings
- SMD LED Focus Beam light
- USB Power Outlet (5V, 1.1A)
- State of Charge / Charging Status LED Indicator
- Dual Magnets on Rear of Unit
- Dual Mounting Hooks
- AC Wall Charger
CHARGING
NOTE: CHARGE THE WORK LIGHT IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE, AND AT LEAST EVERY 3
MONTHS WHEN NOT IN USE. Failure to do this will reduce
the battery's useful life.
Connect the pin jack end of the charging cable to the pin jack
port on the work light. Connect the USB end of the charging
cable to the USB port of the AC charger. Plug the AC charger
into a functioning AC outlet.
The blue state of charge / charging status LEDs will blink
in succession to indicate charging progress. To reach full
charge, continue charging until all four LEDs are lit solid.
Charging will take approximately 4 hours, depending on the
unit's state of charge at the start of the cycle.
The charging process is fully automatic and the light can
remain connected to the charger indefinitely without adverse
consequences.
5