Cleaning And Care; Troubleshooting - Klarstein 10031219 Manual Del Usuario

1. Pull out the power plug and cool down the appliance completely before cleaning.
2. Wipe the body by soft cloth with little neutral cleanser.
3. The pan should be wiped with wet cloth not the attrition sex scavenger (steel brush) to protect the stick
coating.
4. Pour hot water into the pan if the stirring paddle is hard to lift and no attrition sex scavenger to wipe in case
of damaging the stick coating.
5. All parts should be mounted back to the appliance after cleaning and wiping.
Problem
Heat-elimination tube
smokes when baking.
The middle of the
bread is sunk with thick
bottom.
It' s hard to take out the
bread.
The ingredients can't
be mixed and stirred
completely which
results in the effect of
baking.
The LCD shows "HHH"
When pressing On/Off.
29

Cleaning and Care

Troubleshooting

Possible Cause
Ingredients may stuck to the heat-
tube or nearby.
The tube is equipped with
protection oil for the first time.
Too much time to warm the bread
in the pan caused too much loss
of water.
The kneading paddle is stuck to
the axis of pan tightly.
Not proper programmer.
Press On/Off which stops the
operating programmer.
Open the cover several times
when operation which results in
drying and yellowing the bread.
The resistance of kneading is too
strong to make the dough stirred
inadequately.
The temperature in the oven is too
hot to start the appliance.
Solution
Pull out the plug and clean the heat-tube.
Smoke and smell will diasappear when you
use the unit several times.
Take out the bread as soon as it's done.
Taking out the bread, pour hot water into the
pan for 10 min and lift the kneading paddle,
doing cleaning
Check if your recipe accords with the selected
programmer.
If the breakdown time is over 20 min, re-
organize the ingredients; if less than 20 min,
just press ON/OF to re-start the appliance.
Do not open the cover after yeasting.
Check if the hole of the kneading paddle is
broken. Check if the kneading vane works
well.
Press START/STOP, pull out the plug, and
take out the pan, open the cover to cool
down the appliance.