Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Wire Loop Selectable Features :
Wire Color
Gray Loop
Green Loop
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver's door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection
First
Second
Third
Fourth
Fifth
Sixth
To program these selectable features;
Action
Turn ignition on
Flip valet switch on then off 3 times
Within 3 seconds, turn ignition Off
First
Then On
Press transmitter button 1 to change
Second
Flip valet switch on then off
Press tranmitter button 1 to change
Third
Flip valet switch on then off
Press transmitter button 1 to change
Fourth
Flip valet switch on then off
Press transmitter button 1 to change
Fifth
Flip valet switch on then off
Press transmitter button 1 to change
Sixth
Flip valet switch on then off
Press transmitter button 1 to change
Flip valet switch on then off
Turn ignition key off
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
SELECTABLE FEATURES
Closed Loop
Custom Code Manual Override
Voltage Sense
1 Chirp
1 Second Door Locks
Auto Lock On
Auto Unlock On
No Function
Passive Door Locks
Passive Arming
o r
o r
o r
o r
o r
o r
o r
Cut Loop
Valet Switch Manual Override
Hardwire
2 Chirps
3.5 Second Door Locks
Auto Lock Off
Auto Unlock Off
No Function
Active Door Locks
Active Arming
System Response
No response
1 Chirp - LED 1 flash
Short chirp, then long chirp
1 chirp = 1 second door locks
2 chirps = 3.5 second door locks
2 chirps = auto locks off
1 chirp = auto locks on
2 chirps = auto unlock off
1 chirp = auto unlock on
1 chirp = No Function
2 chirps = No Function
1 chirp = passive locks
2 chirps = active locks
1 chirp = passive arming
2 chirps = active arming
Exit program mode
Exit program mode
Page 1
Model APS 400
Installation Manual
Default
1 Second
Auto Lock Off
Auto Unlock Off
—————————-
Passive Locks
Active Arming