BLACK&DECKER VEC156BD Manual De Instrucciones página 3

• Except for the 6 volt/55 watt halogen bulb, there are no user-serviceable parts inside. Do not attempt
to disassemble any other parts of the unit.
• To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting.
• Do not attempt to use the unit if the cord is damaged – return the unit to manufacturer for repair.
SAVE thESE inStRuctionS
iNtroduCtioN
Thank you for choosing the Black & Decker 1,000,000 Power Series™ Spotlight. Please read this
guide carefully before use to ensure optimum performance and to avoid damage to the unit.
FeatureS
• Powerful, focused quartz halogen beam
• Protective rubber safety guard (bezel) around lens
• Comfortable pistol grip and lanyard
• Charging Status LED Indicator displays battery charge status
• UL listed, built-in 120 volt AC charger
• 12 volt DC charging adapter included
• Rechargeable, non-spillable, sealed lead acid battery
Controls and Functions
5
3
4
2
1
1. Pistol Grip Handle
2. On/Off Trigger
3. 12V DC Charging Port
4. Rubber Bezel
5. Quartz Halogen Bulb
VEC156BD_ManualENFRSP_072512.indd 4-5
6
7
8
9
10
6. Charging Status LED Indicator
7. Built-In 120 Volt AC Charger (Back of Unit)
8. Trigger Lock
9. 12 Volt DC Charging Adapter
10. Carry Lanyard (optional accessory)
4
ChargiNg/reChargiNg the light
This unit is shipped in a partially charged state. The charging status LED indicator lights solid while
charging and flashes when the unit is fully charged. Charge unit after purchase and BEFORE first use
using the built-in 120 volt AC charger for 14 hours or until the Charging Status LED Indicator flashes.
When the spotlight dims, the unit needs for recharging. Charge after each use.
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at least every
30 days.
Charging/recharging using the 120 Volt aC Charger and a Standard household
extension Cord (not included)
• Make sure the Spotlight is OFF (the Trigger Lock is in the OFF position and the Trigger is not
depressed).
• Plug a standard North American 120 volt AC extension cord into the 120 Volt AC Charger on the
back of the unit.
• Charge until the Charging Status LED Indicator LED flashes (approximately 12-14 hours). DO NOT
CHARGE FOR LONGER THAN 14 HOURS.
Charging/recharging using the 12 Volt dC Charging adapter
• Make sure the Spotlight is OFF (the Trigger Lock is in the OFF position and the Trigger is not
depressed).
• Plug the barrel tip of the supplied 12 Volt DC Charging Adapter into the 12 Volt DC Charging Port.
• Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power
source.
• Charge until the Charging Status LED Indicator LED flashes (approximately 12-14 hours). DO NOT
CHARGE FOR LONGER THAN 14 HOURS.
Make sure the DC source (jump-starter, battery pack, vehicle accessory outlet, etc.) is 12 volt DC and
is able to supply at least one half amp at 12 volt DC for 8 hours. This means a battery pack should be
charged with at least 4 amp hours capacity.
Note:
When using a vehicle' s 12 volt DC accessory outlet as a charging source, be aware that some vehicles require you to
turn on the ignition to power the accessory outlet.
WARNING:TO AVOID THE RISK OF PROPERTY DAMAGE:
• NEVER CONNECT THE UNIT TO A POSITIVE GROUNDED VEHICLE.
The 12 Volt DC Adapter must only be connected to batteries with a nominal output voltage of 12
volts. The unit will not operate from a 6 volt battery and will sustain permanent damage if connected
to a 24 volt battery.
oPeratiNg iNStruCtioNS
To turn the Spotlight ON, depress the Trigger.
To lock the Trigger in the ON position, squeeze the trigger switch and move the trigger locking button
(located on the side of the handle) to locked position. The spotlight will stay on until the lock is
moved to the OFF position and the trigger is released.
using the carry lanyard (optional accessory)
The carry lanyard may be used to carry the unit or to hang it for storage. Always adjust the slide on
the cords to keep the lanyard secure around any supporting object.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When light is hung by the carry lanyard, do not shake the spotlight or object that it is hanging from.
Do not hang the spotlight from any electrical wires or anything that it is not secure.
• Only use the carry lanyard for hanging this spotlight. The carry lanyard is not intended to support
additional weight. Do not attach or hang anything additional to the spotlight or risk of breakage may
occur.
TRIGGER
TRIGGER LOCK
5
7/25/2012 2:23:44 PM