Inside The Box; Unpacking; Controls And Connectors; Standby Button - KEF X Serie Guia De Inicio Rapido

FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your
body and must not be co-located in conjunction with any other antenna or transmitter.

Inside the Box

x1

Unpacking

1 2
4
x1
x2
x2
x1
3

Controls and Connectors

4 8
6 5 2 1

Standby Button

Switch On
Press and hold
x2
Press once
Switch Off
Press and hold

Operation Modes

X300A Wireless provides you 3 ways to connect to your music source, Wireless, USB and AUX IN. The
highest priority mode available will be activated automatically when an active signal is detected.
Playback priority is given as below:
Operation mode
Wireless
USB
AUX IN
9
3 7 2 1
Switch on to Wireless setup mode
Switch on to operation
Switch off from operation
Conditions to activate
N/A (Always at the highest priority)
No playback in Wireless mode
1. No playback in Wireless mode
2. USB cable unplugged from computer
1. AC power
2. USB between Left and Right
speakers
3. Standby button
4. USB IN
5. AUX IN
6. SYSTEM GAIN control
7. BALANCE control
8. EQ switch
9. LAN port
5