How To Use; Cleaning & Maintenance - MAXI-MATIC Elite PLATINUM EKT-200 Manual De Instrucciones

HOW TO USE

HOW TO USE:
1. Open the lid by pressing the Lid Lock Release Button (Figure 1).
Fill the kettle with water. Fill the kettle to the desired level. Do
not overfill. Be sure not to exceed the MAX line. To close the
lid, push down until it snaps into place.
2. Always place the 360° swivel base on a flat, level surface.
3. Place the kettle on the 360° swivel base (Figure 2).
•
Check if the voltage at your location is the same as that
of the kettle. Details can be found on the label on the base of
the kettle.
4. Switch the kettle to position '1' (Figure 3).
IMPORTANT: Never open the lid while water is boiling.
5. After boiling, the kettle switches off automatically. Disconnect
the kettle from the electric supply.
Warning: Be careful when opening the lid, the water is
very hot. Wait a few minutes for condensation to evaporate.
After boiling water, the outside of the kettle can be very
hot. Only grasp by the handle.
Do not try to lift kettle body with both hands.
Do not open the lid when pouring.
If the kettle is overfilled, boiling water may be ejected. The
kettle is only to be used with the base provided.
Figure 1
Figure 2
Figure 3
4
CLEANING & MAINTENANCE
Always disconnect the appliance from the power outlet before cleaning. Never immerse
the base area or cord in water, or allow moisture to contact with these parts.
NOTE: Lime Scale forms over time when water is heated. Though scale is natural and
harmless, it may produce a powdery substance or mineral-like chunks that can get
into your hot beverages and affect the taste. While the concealed heating element in
this kettle is designed to help reduce scale buildup, the filter helps prevent particles
from pouring into your beverage
Removal of mineral deposits and Lime Scale
Mineral deposits in tap water may cause the kettle interior to discolor .To remove this build-
up, use Liquid De-scaler, a simple to use, non-toxic cleaner.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder with water and be allowed
to stand overnight. DO NOT BOIL!
2. Empty the solution from the kettle, any stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill the kettle with clean water, bring to boil and
then discard the water. Repeat and the kettle will then be ready to use.
The outside of the kettle can be wiped over with a damp cloth.
Cleaning appearance of housing
Wipe the appearance of housing with a damp cloth or cleaner, never use harsh chemical
cleansers.
Cleaning the filter
Remember to clean the filter with a damp cloth at intervals. The Filter can be detached for
easier cleaning simply by pulling it out. To attach, insert the Filter into the support dent.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of
the kettle.
5