Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7
7E
7B
7C
7E
7C
7B
7 SECURING SPOUT
From underneath sink, place Mounting Washer (7A 7A 7 ) onto Spout Shank (7B) and hand
tighten with Mounting Nut (7C). Align Lift Rod (7D) with slot in Mounting Washer (7A 7A 7 ).
Be sure Spout (7E) is centered and facing forward and tighten the Mounting Nut (7C)
until Spout (7E) is fi rmly secured to sink.
8
8D
8B
8C
8E
8A
8 VALVE PREPARATION
VALVE PREPARATION
V
Remove existing Washers (8A) from Valve Body (8E). Insert Stem Extension (8B) into
Valve Stem (8C) and secure by threading Screw Adapter (8D). Insert Valve Body (8E)
through Adapter Extension (8F). Secure with Set Screws (8G) by using a
Wrench. Be sure Flat Surfaces (8J) from End Body (8E) are aligned with Set Screws
(8G). Do not over tighten! Place Rubber Washer (8H) onto Adapter Extension (8F).
7D
7A
1
/
/ " Minimum
/
1
2
2
8J
8E
8G
8F
8H
8G
3
/ " Allen
/
/
32
32
ENGLISH
9
9A
9C
9B
Recommended Hole Size 1
Recommended Hole Size 1
9 VALVE BODY INSTALLATION
From above sink, insert Valve Body (9A 9A 9 ) through Mounting Holes (9B). The HOT valve,
labeled with Red Tag (9C), should be positioned to the left side of the spout.
10
10D
10E
10B
10A
10A
10C
10D
10C
10 SECURING VALVE BODY
From underneath sink, place Square Washer (10A) onto Valve Shank (10B) and tighten
using Mounting Nut (10C). From above sink, thread Adapter Ring (10D) by hand into
Valve Body (10E). Place Plastic Washer (10F) into Adapter Ring (10D).
3
9A
9B
3
/ " Dia.
/
/
8
8
8
10F
10F
10D
10E
10B
10A
10A
10C
10D
10C
Publicidad
Tabla de contenido
