Service And Maintenance; Storage; Technical Data; Delivery Forms - FINO JETSTEAM PRO Información De Usuario

Do not damage the mains connection, i.e, by
rolling over the cable, pulling or squeezing.
Always remove the mains connection by pulling the
plug from the socket, do not pull the connecting
cable. Protect plugs and connectors of mains
connections against spray water.
Connect the device via the mains connector (see
4.1). Switch device ON at mains switch (1). The
switch lights up red and the device starts to heat up.
The dial on the pressure indicator (4) slowly moves
upwards. After approx. 20-25 minutes, the vessel is
under pressure and the green operating lamp (3)
lights up. The pressure dial is at approx. 5 bar. The
device is ready for operation.
Remove the steam gun from the holder bolt
by hand and place in a water basin.
Water can exit the steam gun after initial operation of
the steam switch (10) or after longer non-use (steam
cools off in the steam hose and condenses).
Set the desired volume of steam using the steam
pressure controller (8). When the device has heated
up, steam cleaning is possible without interruption.
After use, replace the steam gun on the holding bolt.
Switch the device OFF after use to save energy.

6. Service and maintenance

Empty the vessel regularly via the outlet screw on the
vessel floor and allow water with lime residues and
possible impurities to drain off. After draining the
water, close outlet screw tightly and seal with Teflon
tape. Clean device with a dry cloth after use.
6.1 Descaling
Depending on use, but no later than 3 months, clean
with a descaling agent, i.e. FINO KALK-EX.
Fill the water tank of the cold device with water to
75 % and add 50 ml of descaling agent. Allow the
device to heat for 15 minutes. Switch device OFF and
vent steam for approx. 1 minute with the steam gun.
Allow the device to cool down completely until the
water tank is free of pressure. Slowly open the water
filler nozzle and remove. Loosen the outlet screw
on the bottom and empty vessel completely. Rinse
device with fresh water for approx. 2 - 3 minutes.
Retighten the outlet screw on the bottom and fill
device with water (see 5.1). Close water tank secure-
ly, the device is ready for operation.
6.2 Replacing the fuse of the device
If the device cannot be switched on, the fuse may
have blown. Pull the plug of the device from the
socket. Unscrew the fuse holder on the back of the
device directly next to the mains plug connector with
a suitable screwdriver. Replace the defective fuse of
the device with a new fuse, type 250 V/8 A. Screw
fuse holder back in. If the problem persists, contact
technical customer services.

7. Storage

Empty device. Store unit in a dry and dust-free
place.

8. Technical data

External dimensions:
Hose length:
Power rating:
Output:
Tank capacity:
Filling volume:
Operating pressure:
Weight:
Max. steam temperature:

9. Delivery forms

JETSTEAM PRO steam cleaner complete with funnel
and mains cable.
Accessories
FINO KALK-EX descaling agent Art.No. 46093
FINO JETSTEAM PRO wall holder Art.No. 52073
FINO JETSTEAM exhaust steam tray Art.No. 52074
ENU
26.0 x 30.0 x 47.5 cm
120 cm
220-240 V, 50/60 Hz
1500 Watts
6 litres
5.3 litres
5.0 bar
12.0 kg
170 °C
5