Publicidad
Idiomas disponibles
Idiomas disponibles
Charge
WB-RUN the handset comes with a small factory load. It is recom-
mended to download the entire device and then do a load of about 4
hours. To charge the headset using USB-miniUSB cable supplied and
connect it to your computer's USB port and the LED will turn blue.
When charging is complete the blue LED will turn off. Remember to turn
off the device if it is to be used as matched or while on but not in use
consumes power.
Syncronize
If this is the fi rst time I will pair the headset with your device:
1. - With the handset off press PLAY for 7 seconds. Do not release
when you see the fi rst red LED and hold until the LED fl ashes blue and
red fl ashes. At that time the handset is expected to be matched.
2. - On your device into bluetooth settings and search for available
devices. Should appear the name "WB-RUN". Select to match it.
3. - Your device may prompt a key (only for certain models) then type
the code "0000" (4 zeros)
4. - When the headset is paired the LED fl ashes red twice every fi ve
seconds. If not paired blink once every fi ve seconds
5. - If you do not pair the headset, after a minute longer be in standby
pairing and will have to retake the point 1
If you have previously paired device, turning on the headset will
automatically pair (in certain models of mobile devices or computers is
necessary to authorize the handset each time)
Music Function
1. - Ensure that the headset is paired to your device (remember that the
LED fl ashes red twice every fi ve seconds if properly matched).
2. - To play the music press the PLAY button (one touch) to pause the
music and also press the PLAY button (one touch).
3. - To go to the previous song (if you have a list of songs) press the
back button (
back button (
4. - To advance to the next song (if you have a list of songs) press the
back button (
back button (
5. - To increase the volume of hold music hold the button (
5. - To increase the volume of hold music hold the button (
down the volume button and hold (
down the volume button and hold (
volume of the handset will sound a double "beep".
Note that in this way is changing the earpiece volume but not the sound
source, ie you may have to modify by hand the volume of your device
accessing it if you want to increase the master volume.
8
english
) with a single touch.
) with a single touch.
) with a single touch.
) with a single touch.
). When you reach the maximum
). When you reach the maximum
) to hold
) to hold
Publicidad
