AVE DOMINAplus Manual De Instrucciones página 16

Mount the clip-on front panel on the support.
Mount the front panel on the support by pressing deeply into all its surface. All front panel locks
must be fi xed. It is suggested to mount and remove the front panel with the video door phone
NOT powered. Otherwise, temporary malfunction of touch buttons could occur.
Remove the protection fi lm.
1.1 TERMINAL PINS DESCRIPTION
BUS IN Connection to the system BUS
BUS OUT Connection to the next device for an in/out connection
S+ Call repeat
S- Call repeat
P Floor call
BUS AVE + Connection to BUS AVE +
BUS AVE - Connection to BUS AVE -
1.2 CONFIGURATION OF APARTMENT STATIONS BRACKETS
Default values: all video door phones default confi guration is the following:
USER = 127
INTERNAL CODE = 0
Therefore, for the proper operation of the system, always pay attention to dip switches, in order to
confi gure them with the correct value.
For dip switch settings, see the system manual provided with the power supply Ref. 1083/20.
CODE: user code.
Set a number from 0 to 127, according to the following rules:
• In the column there must not be any apartments with the same user code.
• If there are apartment stations in parallel in the same apartment, these must have the same user
code.
• The user codes of the same column must be consecutive.
To set the desired code, use the dip switches from 2 to 8 (2= most signifi cant bit - 8= less
signifi cant bit); the dip-switch 1 must be set to OFF.
16
O N O N
= =