Information About The Assignment Of Ip Addresses - SEH PS Serie Guía De Instalación Rápida

Information about the Assignment of IP Addresses

SEH print servers are shipped without an IP address. When you install the print server for the first time,
the print server checks whether an IP address can be obtained from the boot protocols BOOTP or DHCP.
If this is not the case, the print server assigns itself an IP address via ZeroConf from the address range
(169.254.0.0/16) which is reserved for ZeroConf. A freely definable IP address can be saved manually in
the print server, if necessary.
Automatic Assignment of IP Addresses
The print server assigns itself an IP address via
ZeroConf from the address range 169.254.0.0/16.
Displaying the IP Address
The IP address can be found on the status
page of the print server.
To print a status page, press the status
button of the print server.
If the boot protocols have been enabled (factory
default setting) and a DHCP server is available in
the network, the print server obtains its IP address
via the DHCP server.
Manual Assignment of IP Addresses
Start the Product CD on the client.

 Select the Print Server – Tools menu.
Install the InterCon-NetTool on the client.

192.168.0.67
Start the installation routine.
 Start the InterCon-NetTool on the client.
Mark the print server in the print server list and

start the IP Wizard.
Follow the instructions of the IP Wizard.

Enter the preferred IP address and save it.
5
DHCP/BOOTP
192.168.0.67
en