WAGNER LAGOS Manual Del Usuario página 9

LAGOS
INSTALLATION
Choose a site for installation with as much irradiation as possible. Do not place the
LAGOS in the shade of trees, bushes or buildings, as this will greatly reduce the degree
of efficiency of the LAGOS.
PERFORMANCE
The performance of your LAGOS depends on the time of year. LAGOS is ready for
operation longer in summer than in winter.
How long LAGOS shines at night depends on how long LAGOS was exposed to direct
solar radiation during the day. For example, when the sky is overcast, less solar energy
is available to load the rechargeable battery. During the following night, the duration of
emission of light of LAGOS is therefore shorter.
The duration of emission of light is strongly limited on winter days due to lower exposure
to solar radiation.
NOTE: Clean the solar module regularly with a damp towel to guarantee optimum
performance of the solar collectors. Do not use any solvents for cleaning.
Do not put any pressure on the solar module during cleaning.
FAILURE CORRECTION
If LAGOS should fail to function despite observance of all instructions, please proceed
as described in the following steps :
1) Turn the selector switch several times to the positions „OFF" and „ON"
2) It may occur that your LAGOS is ready for operation but it is covered by
another source of light. In this case, relocate the solar station.
3) Ensure that your LAGOS does not stand in the shade during the day.
4) Check the rechargeable battery for corrosion.
REMOVING / CHANGING THE RECHARGEABLE BATTERY (fig.
Manually turn the solar module-counter-clockwise in order to seperate it from the
●
lamp unit.
Lay the solar module face down.
●
Remove the cover of the rechargeable batteries.
●
Remove the rechargeable battery to re-load it and/or exchange it.
●
Re-assembly is accordingly conducted in the reverse order.
ATTENTION: 1) When removing/replacing the rechargeable battery, the
2) Use Original WAGNER rechargeable batteries only.
3) When inserting batteries, make sure the polarity is correct (+/-)
selector switch must be in position „OFF"!
GB
.
)
5