SUNTEC EGG-8564 design Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

• Do start a boiling process immediately after a
finished boiling process, instead let the appliance
cool down first. This protects the heating element.
Components
1. Lid
2. Bowl for steamed egg
3. Egg holder for 7 eggs
4. Water container
5. Power cord with power plug
6. On/Off switch
7. Base
8. Measuring cup
9. Egg piercer with protective lid
Operation
Operating voltage: 220-240V~, 50Hz, 360W
Please remove all packaging materials.
Before initial operation, please clean the device in accordance with the section "Cleaning".
Boiling eggs:
Please use the following table and the enclosed measuring cup to determine the correct amount
o
of water for your number of eggs and the desired consistency. Please then add the specified
amount of water to the water container.
Please place the egg holder on the base and place the eggs to be boiled with the pointed side
o
down in the egg holder.
Tip: To avoid cracks in the eggshell during boiling, use the egg piercer to poke a few holes on
the top side of the eggs. To do this, remove the protective cover on the bottom of the measuring
cup so the egg piercer can now be used.
Place the cover on the appliance and connect the power plug to the socket.
o
Please press the on/off switch. The indicating light lights up at the switch and the boiling process
o
begins. Depending on the amount of water, the boiling process takes approx. 6-12 minutes.
As soon as the water has evaporated, the unit switches off automatically. An acoustic signal
o
sounds and the cooking process is finished. Please set the on/off switch to the off position to
end the acoustic signal. Remove the appliance from the power supply.
Carefully remove the lid and then remove your boiled eggs. The eggs can become very hot, so
o
it is recommended to take them out with cooking gloves or kitchen towels.
Tip: Put the eggs in cold water. This makes it easier to peel the eggshells.
Steaming eggs:
You can use the enclosed plastic bowl to prepare steamed egg.
o
Fill the water container with 50ml water and then place the egg holder on the base.
o
Place your egg into the bowl and then place the bowl on the egg holder. Put the lid on and
o
connect the appliance to the power supply.
Please press the on/off switch. The indicating light lights up at the switch and the cooking
o
1
2
3
Amount of
eggs
4
5
6 or 7
Water amount in ml
Soft
Medium
33
40
30
37
27
34
24
31
21
28
18
25
Hard
66
64
60
56
53
50

Publicidad

Tabla de contenido
loading

Tabla de contenido