Intended Use; Cleaning And Maintenance - SEA SUNSET BUS Manual Del Usuario

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
Photocells' alignment
If photocells are connected on the BUS it is necessary to line up the same before programming. To do the alignment it is
necessary to start a self-learning cycle of the times. At this point, the gate will stand still, as long as the photocells are not lined
up. Once the photocells have been lined up, push the SET button to restart the self-learning of the times.
Note1: The functioning of this device is tightly connected to the control unit User 2 24V. Therefore read attentively the
configuration of the BUS on the User 2 24V control unit.
Note2: it is advisable to use a cable with measurments which do not exceed 2X1,5 mms and however is not longer
than 30 meters.
Verification procedure
Interrupt for several times the ray with a black cardboard verifying that every time the ray is interrupted, the red LED on the
receiver swithes off.
Red led Function:
RED LED LIT: CORRECTLY ALIGNED. NORMAL QUIESCENT STATE.
RED LED UNLIT: INCORRECTLY ALIGNED OR BEAM INTERRUPTED.
MOUNTING AND FIXATION
SECURITY
The 23102075 device cannot be used as security device (EN 12978).
SPARE PARTS
To obtain spare parts contact:
SEA s.r.l. - Zona Ind.le, 64020 S.ATTO - Teramo - Italia.

INTENDED USE

The photocell 23102075 has been projected to be used exclusivley as photoelectric barrier to be installed in the areas
considered dangerous and in proximity of the gate/leaf, it must be used exclusively for the functioning as interposition between
transmitter and receiver (installed according to the above mentioned instructions).
ENVIRONMENT
Please dispose of this product packaging in a responsible, appropriate way.
STORING
T
min
-20 °C
When being transported this product must be properly packaged and handled with care

CLEANING AND MAINTENANCE

Cleaning and maintenance of this unit must be carried out at 6 monthly intervals by authorised, qualified personnel. During
routine maintenance the following checks should be made: Correct alignment, sealing, cleanliness of the lenses and internal
components. Any remedial work should be carried out as required.
DECOMMISSIONING
If the 23102075 photocell is to be taken out of service, this work must only be undertaken by authorised, qualified personnel.
LIMIT OF GUARANTEE
The 23102075 photocell is guaranteed for a period of 24 months. The guarantee period starts from the date stamp printed on
the product. The guarantee will be void if the photocells have been incorrectly installed, not used for the purpose intended,
tampered with or modified in any way. The validity of this guarantee only extends to the original purchaser.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY CAUSED BY
IMPROPER USE OF THIS PRODUCT.
SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice.
Cod. 67410886
®
SEA S.r.l.
DIREZIONE E STABILIMENTO:
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344
21 mm
Fig.2
30 mm
STORAGE TEMPERATURES
T
max
+70 °C
English
Ring
Fig.3
Humidity
5% no condensation
Rev. 00 - 10/2009
http://www.seateam.com
e-mail:seacom@seateam.com
Base
Ring Fixing screw
Electric circuit
Fixing screw
Ring
Cap
Cap lock screw
min
90% no condensation
Cap lock screw
Cover-screw cap
Humidity
max
Pag. 2