Load Capacity - Car Mate INNO XA927 Instrucciones

5
Mount carrier on car
④ Always set the flat washer and the spring washer to the square bolt, then securely tighten the long nut using the wrench included in this
product's package.
Due to applied screw locking agent, the bolt may resist when tightening. Regardless, tighten the bolt until the main unit is secured.
Close the upper arm.
⑤
④
3N ・ m
2.2ft-lb
Spring Washer
Flat Washer
6

Load capacity

See following table to see carrying capacity.
XA927 XA928
Skis
6 3
Skis+Ski poles 4 sets 2 sets
Snowboard 4 2
Snowboard+Skis
2+3
Load capacity may vary by size, width
and thickness of the ski & bindings.
7
Load the gear
After loading ski/snowboard, lower upper arm to close securely.
click!
Load the Skis
Join a pair of skis together,
then load them with their tails
facing the front of the vehicle.
Tail
Front of the vehicle
50 80
mph ( km/h) or less
Binding Crossbar
8
Lock the key
The carrier locks the gear together with the system itself. Always
lock the carrier when not in use.
3N ・ m
2.2ft-lb
Spring Washer
Flat Washer
Caution
Load capacity may vary by vehicle. Check the
loading capacity of the crossbar itself.
Do not load anything other than skis, ski poles
and snowboards.
Note
The upper arm has a 2 step closing
mechanism. For thick skis the arm will
click once. For thinner items like a
snowboard. The arm will click twice.
Load the Ski poles
Tie up grips with straps in order
to avoid hitting car roof.
Caution
If the bindings do not fit between the front
and rear crossbars, move the snowboard
so that one of the bindings is on the front
side of the front carrier, and make sure
you do not exceed 50 mph (80 km/h)
when driving.
Unlock Lock
⑤
Upper Arm
the thickness is up to 2.0 inch (50 mm)
50mm
Load the Snowboards
Secure the straps on the
snowboard binding before loading
the snowboard facing down.
binding
Fix with the
strap
- 2 -
Make sure that the carrier does not
loosen even when shaken with
enough force to rock the car.
Stacked skis should not exceed
to 2.0 inch (50 mm). Use thicker
ski towards the opening side.
40mm
In the back part (hinge part), skis and
snowboards with a thickness of up to
1 inch (40 mm) can be loaded.
When loading short ski/snowboards on to
the carrier, please check to see if the
carrier is properly adjusted for the short
ski / snowboard.
Open the upper arm and load the ski /
1
snowboard. Slide the ski / snowboard
forward and backward until it hits the
front and rear carrier. Make sure the
ski / snowboard head and tail does not
come off from the carriers.
Do not load the skis / snowboards if
2
they appear to come loose from the
clamp.
Caution
Always lock and secure the carrier with a
key before driving.