Reset To Zero; Tare Function - Gram AM Serie Manual De Utilización

the message "CAL?".
3. Press the MODO key, the display will show "YES" and after a while it will
show "LOAD XX OR XX" (XX is the weight calibration value).
4. Carefully place the appropriate weight calibration in the centre of
weighing pan.
5. The balance will accept automatically the weight value.
6. When the message "Done" appears on the display, it means that calibration
has been completed successfully.
7. The balance will show the calibration weight value.
8. If you wish to cancel calibration procedure, press the TARA key.

RESET TO ZERO

When it happens that the balance is on with no object on the weighing pan
but the display is not showing zero (0) and the zero indicator is not lighting,
press the ON-CERO key to correct the reading.
The balance has an internal zero correction (auto zero), this system is
disconnected when the balance is tared or has an object on the platter.

TARE fUNCTION

This function allows obtaining the net weight of a product placed in a
container.
1. With display showing zero "0", place the container on the weighing pan.
9