Chicago Electric WELDING 68885 Guia De Inicio Rapido

WARNING
To prevent serious injury, read manual warnings and instructions before use.
Spool Knob
Spool Spring
Upper
Spool Plate
Wire Spool
Lower
Spool Plate
Spool Spindle
WARNING
To prevent fire and
serious injury:
Keep torch and
wire clear of
grounded objects
while welder
plugged in.
HOLD
GUN
CLEAR
BASIC WELDING INSTRUCTIONS AND WELDING TIPS ARE IN MANUAL.
1
Assemble face shield handle and lens.
Install wire spool.
Insert wire through both
wire liners and clamp it
2
into feed mechanism.
See manual if
changing wire size
or using solid wire.
Take off nozzle and tip,
3
plug in welder, turn it on,
and squeeze trigger until
wire comes out.
clockwise
Incrementally tighten
wire feed tension
4
knob clockwise until
wire will bend from
feed tension at 2"-3".
Unplug welder and
replace nozzle and tip.
5
Adjust wire feed speed
and current settings
according to chart.
6
Hold gun clear of workpiece,
then plug in welder and turn it on.
68885 QUICK START GUIDE
Wire Spool
Contact
Nozzle
wood
block
MIG 170
WIRE FEED WELDER
ITEM 68885
Specifications
.023"-.035"
Wire
(Tip and roller change required)
Capacity 22 Ga. – 1/4" Steel Plate
Material Mild Steel and Stainless Steel
Types (Not for welding Aluminum.)
MIG 170
WIRE FEED WELDER
ITEM 68885
Specifications
.023"-.035"
Wire
(Tip and roller change required)
Capacity 22 Ga. – 1/4" Steel Plate
Material Mild Steel and Stainless Steel
Types (Not for welding Aluminum.)
welding
wire
Tip
I
O
WIRE FEED SPEED
240V~
20A
I
O
WIRE FEED SPEED
240V~
20A