Publicidad
Read the instructions before using the item and store it in a safe place for reference.
USE
Air quality:
Good
Moderated
Poor
Speed
Mode
Remove the front cover by pulling one side of the top fi rmly out.
Take out the fi lter from inside by gently pulling the handle. Then remove the protective plas-
tics from the fi lter, if present.
Then insert the fi lter back into the slot carefully.
Install the front cover carefully from the bottom up. Make sure it is installed correctly.
Connect the device to the mains. Once connected, you can use either the control panel or the
remote control to set up the device.
This air purifi er has three modes operating modes:
- Standby (sleep): Silent night mode. Works in automatic
- Normal: Works in a personalized way so that it works according to your preferences
or needs.
- Auto: the device is self-adjusted according to the air quality detected.
Level of particles
Timer
On / off
UV lamp
ion generator
Automatic mode
The control panel of the device has four buttons:
- On / off : To switch on and off
- Speed: Sets the air speed low, medium or high.
- Timer: Selects the operating time from 1 to 8 hours. The device switches off when
the set time is over.
- Mode: There are three operating modes to choose: stand-by, automatic or normal
The remote control has the following buttons:
- Filter reset: counts the operating hours of the device
- On / off : To switch on and off .
- Timer: Selects the operating time from 1 to 8 hours. The device switches off when
the set time is over.
- Speed: Sets the air speed low, medium or high.
- Sleep: Selects the stand-by mode.
- Auto: sets the automatic mode
- UV Sterilize. Turns the UVC lamp on / off . (Function only available on the remote)
- Anion: Turns the ion generator on / off (Function only available on the remote)
MAINTENANCE
Unplug the power cable before cleaning.
Clean the device gently with a soft, dry cloth.
Use a soft brush to remove the dust deposits in the air inlet and outlet.
Filter replacement
Remove the front cover by pulling one side of the top fi rmly out.
Take out the inner fi lter by pulling the handle and remove the protective
plastics. Then insert the fi lter back into the slot carefully.
Install the front cover carefully from the bottom up.
Make sure it is installed correctly.
UV lamp replacement
Remove the front cover by pulling one side of the top fi rmly out.
Take out the inner fi lter by pulling the handle
The lamp is exposed.
Replace the UV lamp.
Place the fi lter and cover
Publicidad
