Publicidad
Enlaces rápidos
Publicidad
Manuales relacionados para Techni Mobili RTA-3325
Resumen de contenidos para Techni Mobili RTA-3325
- Página 1 MODEL RTA-3325...
- Página 2 MODELO RTA - 3325 Gracias por comprar uno de nuestros productos. Por favor lea cuidadosamente las instrucciones de ensamblaje antes de instalar la unidad. Por favor guarde este manual para referencias futuras.
- Página 3 RTA-3325 DIMENSIONS Product Size: 60"W x 23.5"D x 35"H MAXIMUM WEIGHT CAPACITIES DO NOT exceed this limit Please use care and good judgement when placing objects on wood surface...
- Página 4 x1SET Left Right Izquierdo Derecho Top Glass Panel Main Glass Panel Panel de vidrio superior Panel de vidrio principal Panel de vidrio laterales...
- Página 8 Use screws L to assemble the Horizontal Tubes (3) between the Main Panel (1). Please pay attention to the orientation of the parts as indicated. Use Tornillos L paraensamblar los Tubos Horizontales (3) entre los Paneles Principales (1). Por favor preste atenci n a la orientaci n de las partes como se indica. ó...
- Página 9 Use Tornillos B para fijar las bases de los Deslizadores (6) a los Tubos de Soporte (8) poniendo mucha atenci n de los deslizadores puedan deslizarse hacia el frente del ó mueble.
- Página 10 P.10 Insert the Bolts (G) into the holes of the Right Main Panel (1) and tight them with the tool, then place the CPU Panel (5) over the Bolts and tight the cam locks on the back face of CPU panel (5).
- Página 11 P.11 Insert the Bolts G into the holes of the Lateral Panels (10) and tight them with the tool, then assemble the Horizontal Panel (12) with this bolts. Insert the Tubules (11) between the Lateral Panels (10) and tight the cam locks on the back face of the Horizontal Panel (12).
- Página 12 P.12 Use screws D to fix the Main Glass Panel (15) to the Horizontal Tubes (3). Use Tornillos D para fijar el Panel de Vidrio Principal (15) a los Tubos Horizontales (3). ATTENTION: To avoid misalignments with the glass, screw loose and do not tighten until all screws are in place.
- Página 13 P.13 Use Screws E to assemble the Short Tubes (13) to the Main Glass Panel (15) and make sure to place the washers J&K on top and below the Main Glass Panel (15) respectively. Use los tornillos E para ensamblar los Tubos cortos (13) al Panel de Vidrio Principal (15), colocando las Arandelas J y K encima y debajo del Panel de Vidrio Principal respectivamente.
-
Página 14: Care And Maintenance
CARE AND MAINTENANCE English - DO NOT EXPOSE THE SURFACES TO DIRECT SUNLIGHT, OR EXTREME ENVIRONMENTAL CONDITIONS. EXPOSURE WILL DAMAGE THE PRODUCT, WHICH IS NOT COVERED BY THE WARRANTY. - DO NOT USE SOLVENTS OVER SURFACES OR STRUCTURAL TUBES. SURFACES MUST BE CLEANED WITH A SOLUTION OF A SMOOTH SOAP AND WATER, THEN CLEARED WITH A DRY TOWEL.