S&P HET-1800 Manual Del Usuario página 11

Prevent the power cable from touching the body of the

device during is working.
If the cable gets damaged and has to be changed, do not

do this yourself – take the equipment to an authorised
repair centre because the work must be done by specialist
personnel to avoid any risk of damage.
Do not use the heater as a clothes or towel dryer.

This heater is not equipped with a device of room

temperature control. Do not use this heater in small rooms
that are occupied by people who can not leave the room
by themselves, unless ongoing monitoring is assured.
3. Mounting
 Read the safety warnings before starting product mounting.
 We recommend a minimum of 2 people for mounting the base.
 Lay on a soft surface on the body. Using the allen wrench, assemble the base to the
body using the 4 screws provided (Figure 2).
4. Use of equipment
 Connect the plug into the power point. Use the switch (Figure 1F), to connect and
disconnect power to the device.
 The led (Figure 1G) indicates if the device is connected.
 With the remote control you can turn on and/or turn off each lamp at a distance. Point
the remote control to the control panel (Figure 1C).
 Using the control panel switches (Figure 1H) it is also possible to turn the lamps on
and off manually.
Model
HET-1800
5. Maintenance

Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
 This product does not require special maintenance. It needs to be cleaned periodically
to prevent accumulation of dust on the lamps, as this may cause overheating of the
heater. Clean the lamp with a brush and the body of the product with a damp cloth.
Lamps Lamp power
2 2 x 900W
11
Total power
1800W