Assembly - oneConcept 10033030 Manual Del Usuario

EN
14

ASSEMBLY

Unpacking the product contents
• Unpack all parts and make sure that the scope of delivery is complete and
check for any damages from transport.
• If you identify damages to the components, do not use them .
• If necessary, remove any piece of paper or sticker etc. from the dust bin.
Inserting /removing the hose
• Insert the suction hose connector into the
suction opening on device (see arrow). It
must audibly lock into place.
• To remove the suction hose push the knob
on the connector and pull the suction hose
out.
Inserting/removing the telescopic tube
• Insert the open end of the handle into the
corresponding opening on the telescoping
tube. In the process, turn the handle back and
forth somewhat. Check to make sure that the
connection is secure.
• To remove the telescoping tube pull it off of the
handle.
Adjusting the length of the telescopic tube
• Push the slider on the telescoping tube down and set the desired length.
• Release the slider and move the tube forward until it locks into place.
Mounting/removing suction nozzles
• Insert the open end of the telescoping tube in
one of the enclosed suction nozzles up to the
stop. Turn the nozzle back and forth slightly in the
process.
• The suction nozzles can also be attached directly
to the suction hose without the telescoping tube
for more flexibility.
• To remove a suction nozzle pull it off.