Trumeter 7911 Manual De Instrucciones página 5

Programming Flowchart
To enter programming mode press and hold Programming Key 1 and Programming Key
2 simultaneously. The word "PROG" appears and a counter in the bottom right hand
corner of the display begins counting down in seconds from 3. The unit adopts
programming mode which is illustrated in the flowchart.
Whenever you enter programming mode the values displayed are the last known
settings. Key 1 switches the display between the options in each function and Reset
moves on to the next function. To accept the settings use the Reset key to cycle through
all the functions without making any changes.
Pro9 = Program
dP = Decimal Point
rLy = Relay
nO = Normally Open
nC = Normally Closed
+ to enter PROG
Reset
Reset
Reset
Repeat cycle with NO changes to exit prog
Reset
Reset
Reset
Reset
Reset
Reset
5