Step 4, Connect Power; Step 5, Install Filters, Check Operation; Cleaning - GE PVB37 Instrucciones De Instalación

4 coNNecT poWeR
Plug power cord into properly grounded receptacle.
5 INSTAll fIlTeRS, check opeRATIoN
• Press and hold the ON/OFF pad on the control
to raise the vent.
• Slip fingers into the vent holes. Lift the vent
straight up and then down.
• Slide filter into the retainers and close the vent.
• Press the Fan Speed hIGhER pad to start the
blower. Adjust the blower by pressing hIGhER or
LOWER. The blower, if left on, will automatically
turn off when the vent is lowered.
Filter Tabs
NoTe: It is not necessary to turn the fan OFF
before lowering the vent. The fan will automatically
turn off when the vent is lowered. When the fan
is not turned off before lowering the vent, it will
automatically come on at the previously set speed
when the vent is fully raised.
To lower the vent, press the ON/OFF pad.
IMpoRTANT: The vent can be activated by pressing
the pads on the switch. Do not use excessive force
or sharp objects to activate the switch. Damage
could occur and void the warranty.
Installation Instructions
13

cleANING

painted or Stainless Steel Surfaces
To clean the stainless steel or painted surfaces,
use warm, sudsy water or a stainless steel cleaner
or polish.
The filters should be washed by hand. Do not clean
filters in the dishwasher.