Fan Assembly - HJM FE-30 Instrucciones De Uso

Ventilador Alta Pot. FE-30,40,45_Maquetación 1 05/12/16 15:46 Página 12
9. To disconnect, grip the plug and pull it from the wall outlet, never
yank the cord.
10. Always use on a dry level surface.
11. Do not hang or mount fan on a wall or ceiling.
12. Do not operate the fan without protective front and rear grilles in
position.
13. Be careful not to place the fan too close to the edge of the surface.
14. Do not use outdoors.
15. Do not let the power cord hang over the edge of a table or coun-
ter or let is touch any hot surfaces.
If the supply cord is damaged, it must be replaced by the manu-
facturer or its service agent or a similarly qualified person in
order to avoid a hazard.

FAN ASSEMBLY

1. Install the U shaped tube to the height adjustment tube using
screws.
2. Install the support tube to fan main body using screws.
OFERATION
1. Set your fan on a level dry surface.
2. Plug the power cord into a standard 220~240 V wall outlet.
3. To operate your fan, turn the control knob to the desired fan speed
Low(1),Med(2)High(3)
4. Adjust the fan head to your desired angle.
- 12 -
E
N
G
L
I
S
H