Albrecht BPA 300 Manual Del Usuario página 7

•
Follow the instructions on the Bluetooth mobile phone to complete the headset pairing. When the mobile
phone prompts for a pin code or password enter 0000.
If pairing is not completed within 60 seconds, the red-green flashing will stop and in that case, you can repeat the
steps described above. The screen on the Bluetooth mobile phone or navigator will display the pairing status.
When pairing is successful, the screen on the Bluetooth mobile phone will display a pairing successful message
(or similar) and the LED indicator on the headset adapter will show
•
Standby
•
Connected ready for talk (green 2 x flashing every 3 seconds)
connection status requested from the other device side).
Now the headset is successfully paired and ready to make and receive calls or announcements.
IMPORTANT NOTES
•
If You need a connection to a Navigator and mobile phone at the same time, You must pair the phone
with the navigator first and separately the Navigator with the headset adapter!
•
In case of BPA 100 / BPA 200 / BPA 300 or Midland 445 BT there is no need to enter any PIN code.
The BPA 300 is automatically detected after starting the pairing mode.
Starting the communication
•
Both Bluetooth devices must be switched on.
•
Just press the button shortly at the BPA 300 (and / or on the other device) The LED will change to
connect ready mode (mobile phone) or directly into talk mode (voice connection)
The different Bluetooth handsfree- or headset- protocol implementations in some devices may request to start
the communication at the headset adapter by pressing 1 x shortly the knob, or You may be able to start the
communication at the other device. Just test which knob You need to push. Both devices are connected in talk
status, as soon as BPA 300 shows 3 x green LED flashing every 3 seconds
Not all mobile phones may support all of the below described possible functions, please refer to the operating
guide for your Bluetooth mobile phone for compatibility. For motor bike use, the best way of communication is to
select "automatical call acceptance" at the mobile phone. Only in that case you can accept incoming phone calls
without pressing any knob. Please be aware that any communication through a mobile phone can be dangerous
during driving a motor bike. If possible, stop driving and find a parking lot for making your phone calls.
Accepting incoming calls
If You have not programmed automatic call acceptance in Your mobile phone, You will hear the ring tone in the
headset when there is an incoming call on your mobile phone. You can now accept the call by simply pressing
1x for a short time on the button on the adapter. Please wait at least 1 or two ring tones before you press the
knob.
Rejecting phone calls
If you do not want to accept the phone call, when it is ringing, You can also reject the call. In that case please
press the knob longer (about 2 seconds) after You heard the ring tone(s).
Terminating calls
To end a phone conversation, please press the button on the adapter shortly (or the appropriate button on your
mobile phone). The call will be also finished when the call is terminated on the distant party's side.
Bluetooth mobile phone dialling
Always stop driving before starting an outgoing call and dialling. It is not allowed to do any manual action at a
mobile phone during driving.
•
Use the number pad on the Bluetooth mobile phone for dialing.
•
Press the 'Send' button on the Bluetooth mobile phone to dial the number.
•
The conversation will automatically be transferred to the headset.
•
Voice dial is possible by pressing the button 1 x shortly during StandBy mode (if supported by phone)
•
For redialling the last dialled number press the knob 2 x shortly (if supported by phone)
or
, depending on the
.