Adjustments And Service; Seat Adjustments; Ground Speed Lever Adjustment; Speed Balancing Adjustment - Simplicity ZT2000 Zero Turn Serie Manual Del Usuario

B
Figure 13. Seat Adjustment

Seat Adjustments

The seat and ground speed levers should be adjusted
so that operator's elbows are supported by the arm rests
when his/her hands are on the controls, and the ground
speed levers can be moved through their full range of
motion without contacting the operator's legs.
Seat Position Adjustment
Lift the seat adjustment lever (A, Figure 13). Slide the
seat forward or backward to the desired position, then
lower the seat adjustment lever. Make sure the lever
locks into the locking slots (B) in the seat base.

Ground Speed Lever Adjustment

Remove the ground speed lever mounting hardware
(Figure 14) and reposition the lever either up or down
from its original position. Replace the hardware.
A

Adjustments and Service

Figure 14. Ground Speed Lever Adjustments

Speed Balancing Adjustment

If the rider drifts to the right or left when the ground
speed levers are in the maximum forward position, the
top speed of each of these levers can be balanced. Only
adjust the speed of the wheel that is traveling faster.
To Reduce the Speed of the Faster Wheel
1. Loosen the bolt securing the forward adjust plate
(Figure 14).
2. Slide the plate up approximately 1/8".
3. Retighten the bolt and recheck speed balance.
4. Repeat steps 1-3 until adjustment is complete.
WARNING
DO NOT adjust the rider for a faster overall speed
forward or reverse than it was designed.
23