Publicidad
Enlaces rápidos
AUTOMOTIVE PRODUCTS, INC.
STEP BAR ASSEMBLIES
ENSAMBLES DE ESTRIBOS
MONTAGES DE MARCHE-PIEDS
25-2220
25-2225
ITEM
QTY
1,2
2
STEP BAR, PASSENGER (1) AND DRIVER (2)
3
2
PASSENGER BRACKET
4
2
DRIVER BRACKET
5
4
SUPPORT BRACE
6
8
3/8-16 X 1.00" BUTTON HEAD BOLT
7
8
3/8" INTERNAL TOOTH LOCK WASHER
8
24
M8-1.25 X 30MM HEX HEAD BOLT
9
32
8MM FLAT WASHER
10
24
8MM LOCK WASHER
11
8
M8-1.25 HEX NUT
1,2
2
ESTRIBOS, ACOMPAÑANTE
3
2
SOPORTE DEL LADO DEL ACOMPAÑANTE
4
2
SOPORTE DEL LADO DEL CONDUCTOR
5
4
PIEZA DE SUJECIÓNDEL SOPORTE
6
8
PERNOS TERMINALES DE 3/8 -16 x 1"
7
8
ARANDELAS DE PRESIÓN DE DENTADO INTERIOR DE 3/8"
8
24
PERNOS CON CABEZA HEXAGONAL M8-1,25 X 30MM
9
32
ARANDELAS PLANAS DE 8MM
10
24
ARANDELAS DE PRESIÓN DE 8MM
11
8
TUERCAS HEXAGONALES DE M8-1,25
1,2
2
MARCHE-PIEDS
3
2
SUPPORT COTE PASSAGER
4
2
SUPPORT COTE CONDUCTEUR
5
4
RENFORTS POUR SUPPORTS
6
8
PERNOS TERMINALES DE 3/8 -16 x 1"
7
8
RONDELLE A FREIN A DENTS INTERIEURES DE 3/8 PO
8
24
BOULON A TETE HEXAGONALE M8-1,25 X 30 MM
9
32
RONDELLE PLATE 8MM
10
24
RONDELLE A FREIN DE 8MM
11
8
ÉCROU HEXAGONAL M8-1,25
Remove the contents from box and check for damage. Verify all parts are present. Read instructions com-
STEP 1.
pletely before beginning.
Determine passenger and driver brackets. Both front and rear brackets are the same for each side. Attach
STEP 2.
support braces to brackets as shown. Leave loose.
Attach support brace/bracket assemblies to factory tapped holes to underside of rocker panel as shown. Hand
STEP 3.
SEE FIGURE 1.
tighten.
Attach driver side step bar to cradles with the
STEP 4.
AND 3.
Make sure step bar and brackets are properly aligned with vehicle and tighten all fasteners. Recommended
STEP 5.
torque value is 19 Ft. Lbs. for 3/8" fasteners and 23 Ft. Lbs. for 8mm fasteners.
Repeat installation for opposite side.
STEP 6.
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION: 2002-04 HONDA CR-V
APLICACIÓN: HONDA CR-V, 2002-04
APPLICATION: HONDA CR-V 2002-04
2
DRIVER SIDE
LADO DEL CONDUCTOR
COTE CONDUCTEUR
CONTENTS -
CONTENIDO
(1)
Y EL CONDUCTOR
, PASSAGER (2) ET CONDUCTEUR (3)
1
LADO DEL ACOMPAÑANTE
- CONTENU
(2)
SEE FIGURE 1.
Westin
logo facing outward as shown above.
WO:
PASSENGER SIDE
3
COTE PASSAGER
TOOLS -
HERRAMIENTA
12MM SOCKET
12MM WRENCH
7/32" HEX WRENCH
FLAT TIP SCREWDRIVER
RATCHET
TORQUE WRENCH
DADO DE 12MM
LLAVE DE TUERCAS 12 MM
LLAVE HEXAGONALE DE 7/32"
DESTORNILLADOR DE PUNTA
PLANA
MANERAL
LLAVE DE TORQUE
DOUILLE 12MM
CLE 12MM
CLE HEXAGONALE 7/32 PO
TOURNEVIS A EMBOUT PLAT
CLIQUET
CLE DE COUPLE
75-0408 REVISION F 10/18/07
5
4
- OUTILS
SEE FIGURE 2
Publicidad
Manuales relacionados para Westin 25-2220
Resumen de contenidos para Westin 25-2220
- Página 1 APLICACIÓN: HONDA CR-V, 2002-04 APPLICATION: HONDA CR-V 2002-04 AUTOMOTIVE PRODUCTS, INC. STEP BAR ASSEMBLIES PASSENGER SIDE LADO DEL ACOMPAÑANTE ENSAMBLES DE ESTRIBOS COTE PASSAGER MONTAGES DE MARCHE-PIEDS 25-2220 25-2225 DRIVER SIDE LADO DEL CONDUCTOR COTE CONDUCTEUR ITEM CONTENTS - CONTENIDO - CONTENU...
- Página 2 FINISH PROTECTION Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive wax, (e.g. Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to corrosion.
- Página 3 VISTA DE LA INSTALACIÓN DEL LADO DEL CONDUCTOR OPUESTO AL LADO DEL ACOMPAÑANTE FIGURE 3 ILLUSTRE: COTE CONDUCTEUR, EN FACE: COTE PASSAGER Thank You for choosing Westin products Westin Automotive Products, Inc. For additional installation assistance please call 5200 N. Irwindale Ave. Suite 220 Irwindale, Ca.