Sammic EX-30 Manual De Instrucciones página 3

MAIN APPLICATION
It produces special wavelength ultraviolet
ray witch can destroy insects' nerve centre.
It attracts the insect to the fly killer and kill
them by a electrified wire net.
EFFECT
1. The fly killer is most effective for flies
and mosquitoes.
2. The fly killer produces an ultraviolet ray
that attracts insects in early winter.
Thus, insects won't be born next spring.
INSTALLATION
The flykiller can be installed and placed
according the room's conditions.
1. If the fly killer it is hung up in the centre
of the room, the ultraviolet ray will
attract insects from all around the room.
2. If a room is not large enough, hang the
fly killer up on the wall or in a corner.
3. Hanging height: From 2m up to 3m.
Most flies and mosquitoes fly in the
height between 1.5m and 3m.
4. Two ways of installation: Hanging from
the ceiling or leaning against the wall.
5. Install the fly killer in a relatively dark
place. If you install the fly killer in win-
dows, doors etc. sunlight may weaken
its ray. Man-made light does not weaken
the fly killer ray.
USE AND MAINTENANCE
1. Before cleaning, servicing or repairing
the machine, it is necessary to unplug it
from the mains.
2. Turn on the power of the fly killer. It
works when the light is on.
3. It can work 24h at day and can be used
during the whole year.
4. Too much dust can have influence on
the result of light. Too much dirty things
can have influence on the objective of
killing insects. It is necessary to disas-
semble the protective net and clean the
light tube, electrified grid and the cover
of the machine.
Keep the alulminium body clean. The fly
killer is more effective when it is clean.
Do not use corrosive agent to clean.
5. When it's necessary to change the trig-
ger, open the two black plastic covers
and pull out the aluminium cover left or
right.
6. After using the fly killer for many years,
the light wave and the killing result
decrease.
7. How to change the light tube:
-Take catch-up draw out.
-Put the back net down straight and pull
it out separating it from the machine.
-Change the light tubes from back side.
NOTES OF INSTALLATION
1. Ground wire must be connected.
2. The fly killer should be hanged some
height away from the floor. Avoid con-
tact with children.
3. It is necessary to put the power of the fly
killer off to clean it.
4. In the event the power supply cable
should get damaged and have to be
replaced, the repair may only be done by
a SAMMIC approved assistance service
5. The appliance is not to be used in locals
with flammable vapour or explosive
dust.
TROUBLE
The fluorescent lamp is not
on
The electrified grid doesn't
work
6. I ndoor use only. Is not suitable for use
in barns and similar locations
WARNING: An electric shock hazard may
exist if water from a garden hose is direc-
ted to the fly killer, avoid improper use of
extension cord, keep connections away
from moisture and avoid damage of the
cord.
THE VOLTAGE
Alternate current: 220V-240V 50/60 Hz
WORKING RANGE:
EX-30: power 45W for 60 M2
EX-80: power 114W for 100 M2
TROUBLES AND REPAIRING INSTRUC-
TIONS
Please refer to the following description if
there is any trouble.
CAUSE
The fuse is broken
The lamp has a contact fault
or ages
The starter is out of order
The rectifier is out of order Replace the rectifier
The mains connection wire
is poorly connected
The high-tension wire is
separated from the net.
The high-voltage transfor-
mer has a shot circuit
REPAIR
Replace the fuse
Examine or replace the
lamp
Replace the starter
Reconnect the mains or
replace the wire
Re-weld it
Replace the transformer
ENGLISH 3