4-2. Remove the lower housing of the filter and remove the used filter element.
4-2. Insert an O-ring into the sealing groove of the new filter and apply appropriate lubricating oil to it.
element instead of holding the filter element directly by hand to avoid contamination of the filter, reducing its effectiveness.
V. Draining waste material
All filters are equipped with mechanical sewage valves. The sewage valve is a place where impurities and waste oil gathers together, and
oil and impurities will form into a mass or group over time, clogging the draining device. Therefore, it is recommended to carry out routine
inspection and maintenance once a day. It is necessary to remove impurities immediately when clogging occurs.
Remarks:
1>Parts of class ① are wearing parts (which can be replaced on site)
Parts of class ② are available spare parts (which cannot be replaced on site and must be returned to the factory for replacement or
repair)
* Glue or seal shall not be removed!
2>List of parts in this manual contains various types of equipment, and affected by the production batch. SATA may change some of the
parts without further notice.
VI. Exploded view
10
AE5896Q/AE5896P/AE5896S
AE5897Q/AE5897P/AE5897S
中文
EN
DE
RU
KO
PT
Grasp the bottom cover of filter
JA
ES