Functions Of The Control Panel; Remote Control - M Confort E2000 Manual De Usuario

VI. FUNCTIONS OF THE CONTROL PANEL
1. ON / OFF: In Stand-by mode, press this bu on. then the temperature will be
displayed on the screen and the fan will start. When the equipment is turned off,
if it is opera ng in cold mode, the fan will remain in opera on for a few minutes
to dry the filters. Then it will turn off automa cally. Press again if you want it to
turn off immediately.
2. SPEED: Press this bu on to select the fan speed, in LOW-HALF-HIGH-LOW
sequence. The light corresponding to the selected speed will light up. The engine
takes about 5 seconds to start at the first igni on.
3. SLEEP MODE: Press this bu on to ac vate the SUPER LOW speed of the fan.
Press again to return to the previously selected speed.
4. SWING: This equipment has automa c movement of the ver cal grids. Press
the bu on to ac vate the movement. Press again to stop the movement. The
horizontal grids can be adjusted manually.
5. COOL: Press to ac vate the cooling func on. Press again to turn off.
6. IONIZER: Press this bu on to ac vate the genera on of nega ve ions. Press
again to finish.
7. TEMPERATURE: The ambient temperature is displayed on the screen while the
equipment is in opera on.
8. TIMER: Ac vates the device's auto-off func on. It can be selected between 1
and 24 hours. Each press adds 1 hour and is displayed on the screen.
9. REMOTE CONTROL: All the func ons of the equipment can be controlled equally
from the remote control.
15