Midwest Solutions SL54DD Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. Position and hang the Back Panel (F)
against the remaining open end of the pet
home, the back, using the two hangers
attached to the top rung. It will swing
down naturally into position.
INSERTING THE CORNER RODS
IN THE BACK 
9. Just as in step 7, take the remaining two
Corner rods and insert them downward
through the various intersecting loops of
the back corners. Use the guide at the
right, which shows how each panel's
loops should be placed before inserting
the rod on each side. this configuration
should be the same on both sides of the
Back Panel.
10. Insert the Bottom Pan (H) by sliding it
onto the floor of the pet home from the
front. secure the Bottom Pan inside the
pet home with the pan stop attached to
the middle front of the Bottom Panel.
Pan stop
Back Panel loop only
Back Panel over
side Panel Under
side Panel over
Back Panel Under
Back Panel over
side Panel Under
side Panel loop only
Back Panel loop only
4

Publicidad

Tabla de contenido
loading

Productos relacionados para Midwest Solutions SL54DD

Tabla de contenido