Deltaco Gaming GAM-103 Manual Del Usuario página 6

6. Y button
7. X button
8. A button
9. B button
10. Right stick
11. Turbo button
12. LED indicators 1, 2, 3, 4 counting down to up
13. Direction pad
14. ZR button
15. R button
16. L button
17. ZL button
18. USB-C charge port
19. Reset button
Vibration
The controller has 2 built-in vibration motors.
Connect to "Switch"-console
Press and hold the "Home" + "Y" -buttons
simultaneously for 1 second to activate Bluetooth.
Connect the controller via the console's system.
Depending on the language and version of the
system, the menu might look different but it
should be something like this:
Press the "Home"- button from main screen ->
System settings -> Controllers and sensors ->
Change controller.
Follow the instructions on the screen to connect.
The 4 LED lights will flash green and stay lit once
connected.
Calibrate control stick (Switch)
1. Press the "Home"- button from main screen ->
System settings -> Controllers and sensors ->
Calibrate control sticks.
2. Follow the instructions on the screen to
calibrate.
Connect to "Android"
Press the "A" and "HOME" -buttons
simultaneously for 1 second to activate Bluetooth.
LED 2 and LED 3 flashes.
Connect the controller via your device's Bluetooth
settings.
When LED 2 and LED 3 stays lit, the controller is
connected.
Connect to "Windows"
Connect controller to a computer with Windows
with a USB cable.
6
This controller can be used in both XInput and
DirectInput modes in Windows.
The controller defaults to XInput, LED 1 and LED
4 stays lit.
Press and hold "+" and "-" buttons for about 3
seconds to switch between XInput and
DirectInput.
When the controller is set to DirectInput, LED 2
and LED 3 will flash.
Turbo
Turbo works on these buttons: A B X Y L1 ZL R1
ZR
1. Activate turbo: Press turbo button + button that
you want turbo on.
2. Activate automatic turbo: Press turbo button +
on the button that already has activated turbo.
3. Turn off turbo: Press turbo + on the button that
has automatic turbo activated.
Sleep mode
1. When the console's screen powers off, the
controller will enter sleep mode.
2. While connected, the controller will
automatically enter sleep mode after 5 minutes of
inactivity.
Reconnect
To reconnect press and hold the "Home"-button
for 1 second to wake up the controller and
reconnect.
The controller will stay in sleep mode if it can't
reconnect within 10 seconds.
Charging
To charge: Connect a USB cable to the controller
and to a USB power supply. For example a USB
power adapter or a computer.
The 4 LEDs will flash slowly while charging. When
fully charged, the LEDs will stay lit.
LED indicators flashing quickly indicates low
power.
Adjust turbo speed
Turbo can be set to 3 speeds (automatic Presses
Per Second = pps): 5pps, 12pps (default) and 20
pps.
Increase speed: Press and hold the turbo
button(11) + right stick (10) upwards for 10
seconds to increase speed.