Publicidad
IMPORTANT INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER.
WHEN USING ELECTRICAL A PPLIANCES, BASIC PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND PERSONAL INJURY, INCLUDING THE FOLLOWING:
When switching on the appliance for the first time, allow it to run at full power
for about two hours to get rid of the unpleasant smell. Make sure that the room in
which the appliance is located is well ventilated during this operation. It is normal
for the appliance to emit small cracking sounds when you turn it on for the first time.
1.Read all instructions before using this heater.
2.This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
If provided, use handles when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m)
from the front of the heater and keep them away from the sides and rear.
3.Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.
4.Always unplug heater when not in use.
5.Do not operate any heater with a damaged cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner. Discard heater, or return to authorized
service facility for examination and/or repair.
6.DO NOT USE OUTDOORS.
7.This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into a bathtub or other water container.
8.Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from
traffic area and where it will not be tripped over.
9.To disconnect heater, turn controls to off, then remove plug from outlet.
10.Connect to properly grounded outlets only.
11.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or damage the heater.
12.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
13.A heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
14.Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
15.Always plug heaters directly into a wall outlet/receptacle. Never use with an extension
cord or relocatable power tap (outlet/power strip).
16.ONLY USE THE HEATER ON SOLID, STABLE AND FLAT GROUND.
17.Use the unit in a well ventilated area.
18.Do not move the unit when it is still connected to an electrical outlet and always wait
for the unit to cool down before moving, cleaning and storing.
19.Do not touch the heater when in use. Please wait at least 10 minutes before touching it.
20.Extreme caution is necessary when any heater is used near a child or someone
with a physical disability.
2
21.DO NOT leave the unit unattended when in operation.
22.DO NOT cover the unit with any type of cloth while in operation or until fully cooled.
23.DO NOT wrap the power cord around the unit.
24.PLEASE HANDLE THE UNIT WITH CARE.
25.DO NOT operate the heater if the wall outlet is damaged or after a heater malfunction,
if it has been dropped or has been damaged in any manner.
26.DO NOT USE THE UNIT AS A ROOM HEATER.
27.The unit is intended for household use only. DO NOT use the unit in such areas as
construction sites, greenhouses, barns or stables or any place that has flammable
materials.
28.SAVE THESE INSTRUCTIONS
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot, fully insert.
OPERATION:
1. Put the plug insert in/into the power socket.
2. Turn on the heater. Turn left, the heater will work (without oscillation), there are two setting,
the first setting is "low" (600W), second setting is "high" (1200W); Turn right, there are two
setting, both have oscillation function, the first setting is "low"(
"high"(
).
HIGH
3. Turn off the heater if not in use. Turn the knob back to the center of the switch and pull the
plug down.
OFF
CARE AND MAINTENANCE
1. Before cleaning or replacing the fuse, switch the product off and remove the plug from
the power socket.
2. Use a slightly damp cloth to clean the product housing.
3. Do not use detergents, abrasive cleaning liquids, or chemical agents (alcohol, acetate,
gasoline, etc.) to clean the appliance.
4. Store in a dry, dust-free area with the cord wrapped loosely around the unit.
), the second setting is
LOW
LOW: 600W
HIGH: 1200W
: OSC+600W
LOW
: OSC+1200W
HIGH
3
Publicidad
