Tabla de contenido
Publicidad
Programming
Caution: If the optional relay output and/or analog output board(s) are installed in
the DPM, then entering Program mode will cause both relays to release and the analog
output to go to its minimum value (0V or 4 mA) regardless of the input signal value.
To program the base unit and the option boards, follow the instructions below.
1
2
+
PGM
3
4
+
PGM
5
Connect Program Enable to 0V.
2
1
Use the
parameter from the parameter list (see page 26).
The PGM lamp will light.
Release the buttons to see the parameter value.
Press
PGM
Note: The parameters for each option board will only
appear if that option board is installed.
Use the
parameter, as shown on page 29.
Set the display back to
settings.
Go back to 2 to change other parameters.
Note: To set all parameters to their default values:
+
PGM
Disconnect Program Enable.
2
1
,
and
PGM
to see the parameter name.
,
and
1 second
buttons to select a
buttons to edit the
to try out the new
25
Publicidad
Tabla de contenido
