Shelter Logic 70401 Instrucciones De Ensamblaje página 7

7. Door AnD SolID enD PAnel InStAllAtIon
A. Hold end panel at the top center with white inner surface facing inside of the shelter. Wrap the edges of the
fabric panel around the end rib.
B. Disconnect top rail (the horizontal pipes that run from front to back along the top) from the end rib. Pull the
webbing (the black strap) below the cross rail. Reattach the top cross rail to the end rib. Repeat Step B for
side rails (the horizontal pipes that run from front to back along the sides of the unit, near the bend in the
frame where the legs meet the roof).
C. At the bottom, where the webbing exits the pocket on each side of end panel, pull webbing to remove the
slack. Be careful not to pull the webbing through the other side of the webbing pocket.
D. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself. Position the end panel so that it
is centered on the building before fully tightening the end panel.
E. Tighten ratchets, alternating from one side to the other, until the end panel is centered and tight.
WrAP enD PAnel eDGeS oVer AnD AroUnD
PIPe toWArDS InSIDe oF FrAMe.
IMPortAnt!
InSIDe VIeW oF enD rIB
Keep Zippers closed when tightening end panels.
note:
DO NOT INSERT ANY PIPES
INTO THESE POCKETS.
ZIPPerS
WeBBInG
Thread Webbing Into Ratchet
toP croSS
rAIl
SIDe croSS
rAIlS
coVer
rAIl
Webbing and Ratchets Securing End Panel
Page 7
WrAP enD
PAnel eDGeS
to InSIDe oF
FrAMe
SIDe VIeW oF enD rIB
05_70401-70402-70405_0I