Telstar TFA055910MD Manual De Instrucciones página 19

AIR FRYER
TFA055910MD
Caution: Do not touch the pan during and some time after use, as it gets very hot. Only hold the pan by the
handle.
5. Turn the temperature control knob to the required temperature. See section' Settings' in this chapter to
determine the right temperature
6. Determine the required preparation time for the ingredient (see section 'Settings' in this chapter).
7. To switch on the appliance, turn the timer knob to the required preparation time
Add 3 minutes to the preparation time when the appliance is cold.
Note: If you want, you can also let the appliance preheat without any ingredients inside. In that case, turn the
timer knob to more than 3 minutes and wait until the heating-up light goes out (after approx. 3 minutes). Then
fill the basket and turn the timer knob to the required preparation time.
a The power-on light and the heating-up light go on.
b The timer starts counting down the set preparation time.
c During the hot air frying process, the heating-up light comes on and goes out from time to time. This indicates
that the heating element is switched on and off to maintain the set temperature.
d Excess oil from the ingredients is collected on the bottom of the pan.
8. Some ingredients require shaking halfway through the preparation time (see section 'Settings' in this chapter).
To shake the ingredients, pull the pan out of the appliance by the handle and shake it. Then slide the pan back
into the air fryer and continue to cook.
Caution: Do not press the button of the handle during shaking.
Tip: To reduce the weight, you can remove the basket from the pan and shake the basket only. To do so, pull
the pan out of the appliance, place it on a heat-resistant surface and press the button of the handle.
Tip: If you set the timer to half the preparation time, you hear the timer bell when you have to shake the
ingredients. However, this means that you have to set the timer again to the remaining preparation time after
shaking.
19