Parts List
Part #
Description
A
Basin
B
Bottom Pole
C
Second Basin
D
Middle Pole
E
Third Basin
F
Fountain Upright
G
Pump
H
PVC Tube
I
Cover
Special Warnings
To reduce risk of electric shock, connect only to a properly grounded outlet.
Inspect cord for damage before installation, maintenance or use. If damage is found, replace entire pump/cord assembly.
Do not remove grounding pin from cord.
Do not exceed voltage shown on pump.
Safety Precautions
1. Use proper power source as indicated on the pump label.
2. Keep cord away from high temperatures and sources of heat.
3. Keep fountain out of the reach of children.
4. If in a freeze area, remove water from base and statuette.
5. Remove and store statuette and pump indoors in freezing weather conditions.
6. Always disconnect pump from electrical outlet before handling.
7. Do not let pump run dry.
8. Do not lift pump by its power cord.
9. Do not pump heated liquids.
10. Operate in freshwater only.
11. Pump must be completely submerged for proper operation and cooling.
Care and Maintenance
1. Keep water clean. Distilled water will reduce mineral deposits and improve water clarity.
2. Clean product periodically to prevent mineral deposits and contamination.
3. Disconnect power and empty basin if fountain will not be used for an extended time.
4. If installed outdoors and in a freeze area of the country, make certain all water has been removed from the fountain and it is dry. The
product should not be operated in temperatures below 41º Fahrenheit (5º Celsius). Freeze damage could occur.
5. To eliminate possible water damage to floors and other areas around the fountain, check for leaks and excessive splashing after initial
setup.
6. Place fountain in a location that will not be damaged should the area come in contact with liquids.
7. Do not leave fountain running unsupervised for extended periods of time.
8. Check areas surrounding fountain on a regular basis for leakage.
Item # 157517
4-TIER FOUNTAIN Model #F90570WH
Quantity
1pc
1pc
1pc
1pc
1pc
1pc
1pc
1pc
1pc
Questions, Problems, Missing Parts? Before returning to retailer,
call our customer service department at 866-728-6187, 9a.m. – 5p.m.
EST (Mon.-Fri.) or email customerservice@srg-usa.com.
Tools Required for Assembly
•
No tools required
Preparation
Before beginning assembly, read all warnings and safety precautions.
Remove parts from carton. Compare parts with parts list. If any part is
missing or damaged, do not attempt to assemble or use the product.
Contact customer service for replacement.
1