Hot Surface - Karibu 56391 Instrucciones De Montaje Y De Servicio

Caution! Remove all protective film
before putting into operation
Dear Customer,
Please read these operating instructions carefully before you connect and use
the sauna stove for the first time to prevent causing any damage.
• The installation and electrical connection of the sauna equipment and other
electrical equipment may only be carried out by a licensed electrician. This
does not include items supplied with an integral plug ready for connection.
• Refer to the safety actions required by VDE 0100 § 49 DA/6 and VDE 0100
Part 703/11.82 §4. Even if you comply with the required safety actions it is
not possible to rule out the possibility of all accident risks.
• Follow the safety instructions to the letter to ensure that you can operate
your equipment safely.
• The unit is not designed for use in public saunas.
• Caution – risk of burns. The vaporizer grating and the area around the
steam vent get hot..
• Keep children away from the vaporizer. risk of burns!
• Seek medical advice about the sauna temperature and the safe length of
time in the sauna for people with medical problems and for infants, children,
elderly people and people with disabilities.
• Do not allow the equipment to be used by people, including children, whose
physical, sensory or mental abilities or lack of experience and/or knowledge
render them incapable of using the equipment safely without supervision.
• Do not allow the equipment to be used by people who are under the
influence of medication, alcohol or drugs.
• Do not place any items on the vaporizer unit. They may catch fire.
• Metal surfaces may rust in a damp, saltwater climate.
Read the Caution!
operating

Hot surface

instructions!
Fit the top cover on the housing and secure in place with the two M4x10 mm
screws.
Fit the vaporizer unit as illustrated in Figs. 4 and 5.
When mounting the vaporizer unit on the wall, make sure that there is at least
110 cm between the top edge of the vaporizer and the sauna ceiling and at
least 20 cm between the bottom edge of the vaporizer and the floor. There
must be a minimum clearance of 2 cm from the sides of the sauna. Screw in
the bottom screws to 1 mm with a horizontal clearance of 245 mm (Fig. 5).
Place the vaporizer on them and fix in place at the top with two screws. It is
advisable to fit a protective grating around the vaporizer unit similar to the
safety grille on the sauna stove.
Fit the h/t sensor to the cabin ceiling using two 4 x 15 mm screws. Fit the
sensor in the center or, depending on the size of the cabin, above the center of
the bench (Fig. 6 A / B). Make sure that the air can flow freely through the h/t
sensor. Fit the sensor lead on the wall so that it is covered by a wooden strip,
for example.
vaporizer position
Caution!
Hot steam
example
incoming
air