Akron 8600 Serie Instrucciones De Instalación página 6

VI. Maintenance Instructions for 8620, 8625 Severe Duty Actuators Only
Greasing of the gearbox is not required under normal operating conditions . Check the motor operating
current periodically to confirm the current is within the Normal Operating Current ranges listed under
Product Ratings . If the current has risen above the normal range, it may be necessary to add additional
grease to the gears or to overhaul the gearbox to clean and replace the grease . See Table 1 and Table 2
below for grease volumes .
Periodically inspect the condition of the grease in the gearbox . See the tables below for
recommendations regarding the condition of the grease .
Do not apply grease more frequently than 1 time per month .
Standard recommended grease is Mobilith SHC460 . This is a synthetic hydrocarbon grease + lithium
complex soap thickener, NLGI 1 . 5 grade lubricant . DIN 51825: KPHC1-2N-40 . The color is red .
Use of any grease with an NLGI rating higher than 1 . 5 is not recommended . This may result in excessive
operating currents/stalled motors .
Color (Standard Lubriplate Low Temp grease):
Red
Reddish Brown
Black
Gearbox
Joint:
Worm Gear
ISO 9001 REGISTERED COMPANY
Grease Condition Evaluation (Standard Grease: Mobilith SHC460):
Table 1: Adding Grease to an Assembled Actuator
Table 2: Applying Grease to Disassembled Actuator During Overhaul
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship . Akron Brass will repair or replace product
which fails to satisfy this warranty . Repair or replacement shall be at the discretion of Akron Brass . Products must be promptly returned to Akron Brass for warranty service .
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow
our instructions or recommendations; or anything else beyond our control . WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT,
AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE . Further, we will not be responsible for any consequential, incidental or
indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever . No person has authority to change this warranty .
© Akron Brass Company . 2011 All rights reserved . No portion of this can be reproduced without the express written consent of Akron Brass Company .
Action:
None
Add grease to the gearbox according to Table 1 below
Component needs overhaul . Clean and remove
old grease . Re-apply grease to gears prior to reassembly
according to Table 2 below .
Grease volume:
0 . 5 0 oz . (14 . 8 mL)
Grease volume:
0 . 5 0 oz . (14 . 8 mL)
PHONE: 330 . 2 64 . 5 678 or 800 . 2 28 . 1 161 I FAX: 330 . 2 64 . 2 944 or 800 . 5 31 . 7 335 I akronbrass . c om
REVISED: 10/13