Operating Instructions; Placement And Testing; Continuous Operation; Changing Tools - stayer TM10BA Manual De Instrucciones

3.3 Description illustrated
1. Quick-change drill chuck
2. Locking button
3. ON/OFF switch
4. Speed controller
5. Clockwise/Counter-clockwise switch
6. Clip for belt (TM10CA)

4. Operating Instructions

4.1 Placement and Testing

ON/OFF switch (Fig. 4/Item 3)
- First fit a suitable drill bit into the tool (see 6.1).
- Connect the mains plug to a suitable socket.
- Position the drill in the position you wish to drill.
To switch on:
Press the ON/OFF switch (3)

Continuous operation:

Secure the ON/OFF switch (3) with the locking button (2).
To switch off:
Press the ON/OFF switch (3) briefly.

4.2 Changing tools

Carbon brushes
In case of excessive sparking, have the carbon brushes
checked only by a qualified electrician.
Important! The carbon brushes should not be rep laced by
anyone but a qualified electrician.
Attention! The carbon brushes should be repla-
ced only by an authorized workshop Stayer

4.3 Operations ajuster

You can infinitely vary the speed whilst using the tool.
- Select the speed by applying a greater or lesser pressu-
re to the ON/OFF switch (3).
- Select the correct speed: The most suitable speed de-
pends on the workpiece, the type of use and the drill bit
used.
- Low pressure on the ON/OFF switch (3): Lower speed
(suitable for: small screws and soft materials)
- Greater pressure on the ON/OFF switch (3):
Higher speed (suitable for large/long screws and hard ma-
terials)
Tip: Start drilling holes at low speed. Then increase the
speed in stages.
Benefits:
- The drill bit is easier to control when starting the hole and
will not slide away.
- You avoid drilling messy holes (for example in tiles).
ENGLISH
11
Preselecting the speed (Fig. 4/Item 4)
- The speed setting ring (4) enables you to define
the maximum speed. The ON/OFF switch (3) can
only be pressed to the defined maximum speed
setting.
- Set the speed using the setting ring (4) on the
ON/OFF switch (3).
- Do not attempt to make this setting whilst the drill
is in use.
Clockwise/Counter-clockwise switch (Fig. 4/Item 5)
- Change switch position only when the drill is at a
standstill!
- Switch the direction of the hammer drill using the
clockwise/counter-clockwise switch (5):
Direction
Clockwise (forwards and drill)
Counter-clockwise (reverse)

5. Maintenance and service instructions

5.1 Cleaning and maintenance

Always pull out the mains power plug before star-
ting any cleaning work.
Cleaning
- Keep all safety devices, air vents and the motor housing
free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
- We recommend that you clean the device immediately
each time you have finished using it.
- Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or solvents;
these could attack the plastic parts of the equipment. En-
sure that no water can seep into the device.
Maintenance
There are no parts inside the equipment which re-
quire additional maintenance.

5.2 Repair Service

The service will advise you on the queries that you may
have about the repair and maintenance of your product,
as well as replacement parts.
Exploded views and information on spare parts can also
be found under:
info@grupostayer.com
Our team of technical advisors will be happy to guide as
to the acquisition, implementation and adjustment of pro-
ducts and accessories.
11
Switch position