Uline H-8254 Manual Del Usario página 4

SHRINK WRAP SYSTEM
1. Plug power cord into 110 VAC 15 A wall outlet.
2. Turn power on by depressing rocker switch. No
warm-up time is required.
3. Plug the heat gun into AC outlet on left hand side
of box.
4. Separate film and place around spreader bar.
(See Figure 1)
5. Pull film to the desired length on the left hand side
of sealing arm and sealing pad. Open film and
insert package. Roll excess film back onto the roll
so that package is approximately even with edge of
sealing pad.
6. Adjust dial to proper setting. Holding package in
left hand, bring the sealing arm down firmly onto
the film and pad until the LED indicator turns off.
Gently pull package away in a tearing motion
until package is completely separated from pad.
Release the arm and turn the package counter-
clockwise 90°. Repeat to seal the remaining edge
of film. (See Figure 2)
NOTE: If the cutting and sealing process takes
longer than 3 to 5 seconds, turn up the dial on
the machine. If this does not reduce the dwell
time, call Uline for assistance at 1-800-295-5510.
PAGE 4 OF 15
OPERATION
Figure 1
Figure 2
7. To shrink film around the product: adjust heat gun to
desired temperature. Holding gun approximately 12"
from product, begin to shrink film around the seams
first and then toward the middle in a circular motion
until package has a glass-like appearance.
(See Figure 3)
NOTE: Do not hold gun in the same position for
more than a few seconds. This will cause the
film to burn rather than to shrink.
WARNING! Heat gun should not be left on when
air intake vents are blocked or for a prolonged
period of time to prevent overheating! Make
certain that switch is in the off position to ensure
that both the blower and heating element are
shut off, or heat damage may occur.
8. Always turn your Shrink Wrap System off when not in use.
Figure 3
1219 IH-8254